Many injectable drugs cannot be mixed together in syringes or infusions. Some cannot be safely diluted in infusion bags. Incompatibility can involve precipitation, ionic reactions, evolution of gas and denaturation of biological molecules. Knowledge of drug compatibility is needed before mixing drugs. Reference texts can provide information, but data are often unavailable for new drugs. If drugs are mixed together, the mixture should be inspected for precipitates, turbidity or changes in colour, however not all incompatibilities are visible.
Mixing solutions of parenteral drugs is generally not recommended because of the potential for incompatibility and consequent loss of activity of one or both drugs. However, in some circumstances there may be compelling reasons for mixing two or more parenteral drug solutions in the same infusion bag, in the same syringe or at a Y-site junction where two or more intravenous lines meet. Such circumstances include:
- difficulties with venous access limiting the number of intravenous lines available for continuous administration of multiple drugs
- multiple drugs requiring parenteral administration within a short time frame such as in a home visit by a general practitioner
- patients at home requiring many drugs by simultaneous continuous infusion where multiple intravenous lines are not feasible, for example, use of a syringe driver during palliative care.
The decision to mix drugs should not be made without knowledge of their compatibility. If intravenous drugs are not mixed but are given consecutively, the infusion line should be flushed through with compatible fluid between each administration.
Mechanisms of incompatibility
Incompatibility problems are more likely to arise when small concentrated volumes are mixed in a syringe rather than in the larger volume of an infusion bag. This is because of higher mutual drug concentrations and potentially greater pH changes in the more concentrated solution. The absence of any visible change to a solution upon mixing does not automatically exclude degradation of either or both components.
Drugs that precipitate upon dilution
Precipitation of a drug from its concentrated injection solution when it is diluted with water or saline is counter-intuitive. However, a small number of injection solutions are formulated in non-aqueous solvents to allow dissolution of a poorly water soluble substance in a small volume. In these formulations, dilution of the non-aqueous injection vehicle with water or saline may precipitate the drug.
The problem is frequently observed when diazepam injection is diluted. Diazepam is very poorly water soluble so it is formulated as an injection solution in a vehicle comprising 50% propylene glycol and 10% ethanol. At first, dilution produces a slight turbidity which clears upon mixing, but dilution beyond fourfold produces an opaque white precipitate which does not clear until substantial further dilution.
Other drugs which demonstrate solubility problems and which are formulated in injection vehicles other than simple aqueous solutions include digoxin, clonazepam, phenytoin, amiodarone and phytomenadione. In some cases, the manufacturer recommends administration of the undiluted drug. In other cases, care needs to be taken to ensure that if the injection solution is diluted, the dilution is adequate to ensure continuing solubility over the duration of the infusion.
Precipitation of drugs due to pH change upon mixing
The water solubility of any drug is enhanced by ionisation of the molecule. For a drug molecule which acts as a proton acceptor (a Lowry-Bronsted base), ionisation is achieved by formulation in a low pH solution usually as a hydrochloride or hydrogen sulfate salt (for example, amiodarone hydrochloride or adrenaline acid tartrate). Conversely, for a drug molecule which can lose a proton or hydrogen ion (a Lowry-Bronsted acid - usually a weak organic acid), ionisation is achieved by formulation in a high pH solution, usually as a sodium or potassium salt (for example, benzylpenicillin sodium). Any change in pH towards the other end of the pH scale will reduce the proportion of ionised to un-ionised drug in solution and will therefore reduce the water solubility of the drug.
The most prominent example of a pH-related reduction in solubility is dilution of phenytoin sodium injection. The drug is formulated with non-aqueous solubilising agents and the solution is adjusted to a pH of 12. Dilution of injectable phenytoin by adding it to an infusion bag lowers its pH and therefore reduces its solubility resulting in precipitation of the drug. Glucose 5% infusion solution, which has a pH of 4.3-4.5, will precipitate phenytoin almost immediately. Indeed, phenytoin injection is so incompatible that it should generally not be mixed with any other solution.
Ionic reactions forming insoluble substances
The salts of monovalent cations, such as sodium and potassium, are generally more soluble than those of divalent cations, such as calcium and magnesium. Mixing solutions containing calcium or magnesium ions has a substantial risk of forming an insoluble calcium or magnesium salt. Mixing magnesium sulfate 50% and calcium chloride 10% results in precipitation of insoluble calcium sulfate. The mixing of drug salts of calcium, and to a lesser extent magnesium, with phosphates, carbonates, bicarbonates, tartrates or sulfates should also be avoided. A recent warning has been issued about mixing calcium-containing solutions, including Hartmann's solution, with ceftriaxone causing the formation of the insoluble ceftriaxone calcium salt.1
Denaturation of biological molecules
Biological substances including blood products and insulin are prone to denaturation when exposed to variations in pH and osmolality. While published compatibility data exist for insulins and some of the blood products, most recently marketed biological drugs such as infliximab, interferons and recombinant coagulation factors have no such data available and mixing with other drugs is not recommended.
Evolution of gas
Addition of an acidic drug solution to a solution containing a carbonate or bicarbonate may result in production of carbon dioxide gas. However, the evolution of gas is a normal part of the reconstitution of some drugs, notably ceftazidime.
Use reliable reference material
Some incompatibilities are eminently predictable from simple chemical knowledge, but most compatibilities and incompatibilities are not so easily predicted. For this reason, the decision to mix any two injection solutions whether in a syringe, in an infusion bag or at a Y-site should be based on a reliable reference. However, published data are specific to the concentration, solvent, ambient temperature and sometimes the composition of the syringe or infusion bag. A number of references, in addition to the manufacturer's product information, are available. These include the Australian Injectable Drugs Handbook.2 Table 1 shows some of the compatibility and incompatibility data currently available.
There are a number of drugs that are commonly delivered via syringe driver to patients having palliative care in the community (see box). Combinations of two, three or more of these drugs occasionally need to be co-administered via syringe driver. Specialist references dealing with their mutual compatibilities need to be consulted.3,4
While some general principles can be applied to the mixing of injection solutions, they are fraught with exception and applicability varies with circumstance. Mixing is best avoided. If circumstances are so compelling as to warrant mixing any two or more solutions, there should be support from published compatibility data. A visual check for precipitation, turbidity or colour change should be carried out before administering the mixture, but does not guarantee compatibility.
New guidelines for endocarditis prophylaxis
The Australian recommendations for the use of antibiotics in the prevention of endocarditis have been revised by Therapeutic Guidelines. These changes are consistent with new international guidelines for endocarditis prophylaxis, which have generally reduced the indications for using antibiotics.
The revised guidelines are available free of charge on the Therapeutic Guidelines website www.tg.com.au and in the electronic publications eTG complete and miniTG. The booklet versions of Therapeutic Guidelines: Antibiotic and Therapeutic Guidelines: Oral and Dental will be updated when new editions are published.
Trissel LA. Handbook on injectable drugs. 14th ed. Bethesda: American Society of Health-System Pharmacists; 2007.
Australian Prescription Products Guide. Hawthorn, Vic.: Australian Pharmaceutical Publishing Company; 2007.
Conflict of interest: none declared
The following statements are either true or false.
1. When two drug solutions are mixed together the absence of a visible reaction does not exclude degradation of either drug.
2. Injectable diazepam should be diluted with four parts water to ensure it does not precipitate in the syringe.
Answers to self-help questions
- U.S. Food and Drug Administration. Center for Drug Evaluation and Research. Information for healthcare professionals. Ceftriaxone (marketed as Rocephin). http://www.fda.gov/cder/drug/InfoSheets/HCP/ceftriaxone.htm [cited 2008 Jul 10]
- Burridge N, editor. Australian Injectable Drugs Handbook. 3rd ed. Collingwood: Society of Hospital Pharmacists of Australia; 2005.
- Compatibilities of drugs in syringes. Appendix 2. Palliative Care. Version 2, 2005. In: eTG complete. Melbourne: Therapeutic Guidelines Limited; 2008 Mar.
- Syringe driver survey database. http://www.palliativedrugs.com [cited 2008 Jul 10]